VIN-WRC说明书
PDF
Product Overview
The VIN-WRC Factory Rear Camera Retention Interface is designed to retain the factory rear camera when installing a compatible Vinland head unit.
This module converts the factory rear camera signal and ensures proper video output to the aftermarket radio.
Compatibility
This adapter is compatible with the following vehicles equipped with a factory rear camera:
● Jeep Wrangler (JL) 2018–2023
● Jeep Gladiator (JT) 2019–2023
⚠ Always verify vehicle trim level and factory equipment before installation.
Package Contents
The following components are included:
● Camera Retention Interface
● Rear Camera Retention Interface Harness
● Power Adapter Harness
Inspect all components before installation. If any item is missing or damaged, contact customer support before proceeding.
Required Tools
● Trim removal tools
● Phillips screwdriver
● Electrical tape
● Zip ties
Professional installation is strongly recommended.
Safety Notice
● Disconnect the negative battery terminal before beginning installation.
● Do not power the head unit until all connections are completed and verified.
● Improper installation may result in electrical damage or loss of vehicle functionality.
Installation Procedure
Part 1 – Camera Retention Interface & Factory Rear Camera Connection
Step 1 – Disconnect Factory Rear Camera
Remove the factory radio and locate the factory rear camera connector at the rear of the radio.
Disconnect the factory rear camera connector from the factory radio.
[Rear Ports of the Jeep Wrangler Factory Head Unit]
Step 2 – Connect the Factory Rear Camera to the Camera Retention Interface
Connect the factory rear camera connector to the green input port on the VIN-WRC Camera Retention Interface. Ensure the connector is fully seated and locked.
Step 3 – Connect Video Output to Aftermarket Head Unit
Locate the yellow RCA plug labeled “CAM Video-OUT”.
Connect this RCA plug to the rear camera input on the aftermarket head unit.
Step 4 – Connect the Power Port
Locate the connectors labeled “Video Decoder Box Power Port”.
Connect the matching power connectors between:
● The Power Adapter Harness
● The Video Decoder Harness
Ensure a secure connection.
Part 2 – Power Adapter & ADS Module Connection
Step 5 – Connect Power Adapter to ADS Harness
Connect the female connector from the VIN-WRC Power Adapter to the ADS-specific power harness.
Verify connector orientation before inserting.
Step 6 – Connect Power Adapter to Aftermarket Head Unit
Insert the male connector from the Power Adapter into the main power port of the aftermarket head unit.
Confirm proper alignment and full insertion.
Step 7 – Connect 4-Pin ADS Data Cable
a. Connect the ADS Data Cable from the Power Adapter to the 4-pin ADS data extension cable.
b. Connect the opposite end of the 4-pin extension cable to the corresponding port on the ADS module (RR or RR2).
Ensure all connections click into place.
Final System Check
Before reassembling the dash:
1. Reconnect the vehicle battery.
2. Power on the head unit.
3. Shift the vehicle into reverse.
4. Confirm:
● The rear camera image appears
● Image is stable and clear
● No warning messages are displayed
● If no image is present:
● Recheck the RCA connection
● Confirm all power connections
Installation Completion
After successful testing:
● Secure all modules using zip ties.
● Ensure no wires are pinched.
● Reinstall dash panels.
Installation is now complete.
Troubleshooting
No. | Problem Description | Solution |
1 | No Rear Camera Signal | Verify the factory rear camera connector is fully inserted into the Camera Retention Interface. |
Confirm the yellow RCA is connected to the correct rear camera input. | ||
Check the ADS module configuration. | ||
2 | Intermittent Video | Inspect the ground connection. |
Verify power harness seating. |
Technical Support
For the latest installation manual and firmware updates, visit:
For technical assistance, contact: